Largest choice of products
Next day delivery available
Dedicated technical support

4T Surface Contact with Resistors


4T Surface Contact with Resistors

Part No:
Quick Ref:

In Stock

The D75MULTI is a 4 terminal white surface contact complete with selectable EOL/Alarm resistors. Resistor selection is provided by shunt placement.

A sprung tactile microswitch provides tamper protection, detecting removal of the lid.

EOL Resistors: 1k, 2k2, 4k1, 4k7, 5k6.
Alm Resistors: 1k, 2k2, 4k1, 4k7, 5k6, 6k8.

These resistors cover the majority of leading panel manufacturers including Honeywell, Texecom, HKC, Risco etc.

Both contact and magnet are 78x24x20mm with rounded edges for a smoother look.

The contact can be wired without the integral resistors (Traditional / 4-Wire) if necessary.

D75MULTI is suitable for shared zone installation with 2+ contacts.

Along with fitting screws, this contact also comes with 2x 3mm spacer shims to assist with installations that are not entirely level. Additional shims can be purchased in a 5 pack – use part code SPA-LS.

D75MULTI operates at a gap of approximately 35mm.

Also available in brown – use part code D75MULTIB.
Also available in Grade 3 – use part code YEND74.

  • Operating gap: ~35mm
  • Microswitch tamper protection
  • Integral resistors (shunt selection)
  • Shared zone ready
  • PCB with wire clamping terminal blocks
  • Supplied with fitting screws and shims

Added to your basket

4T Surface Contact with Resistors

4T Surface Contact with Resistors

View your basket