The YH10A is a heavy duty angle contact, sealed against outside attack.
18″ of 8-core fly lead is provided, encased in a steel armoured sleeve. The sleeve itself is capped with a grommet for ease of installation to junction boxes etc. Magnetic interference detection provides Grade 3 functionality.
This contact comes complete with integral resistors, configured by core selection:
EOL Resistors: 1k, 2k2, 4k1, 4k7, 5k6.
Alm Resistors: 1k, 2k2, 4k1, 4k7, 5k6, 6k8.
These resistors cover the majority of leading panel manufacturers including Honeywell, Texecom, HKC, Risco etc.
Two YH10A contacts can share a zone, depending on the configuration of the alarm panel (see instructions).
Note: The integral resistors MUST be used – this contact cannot be wired 4-wire / traditional. For this purpose, use part code H10A or H10C.
Both contact and magnet are 80x25x27mm, angled at 90 degrees from the fitting surface. This contact operates at a gap of approximately 30mm.
Supplied with fitting screws.
8-Core Armoured Angle Contact with Resistors